How do I water efficiently during drought restrictions?

Water the plants that are hardest to replace first, and make every watering count. Colorado State University Extension says trees deserve the most attention during drought, because they’re costly and slow to replace. Then water in the cool part of the day, check the soil before watering, use drip or hand watering for beds, and fix sprinkler problems so water lands where it’s needed.

What to prioritize

  1. Trees, especially young trees with 1- to 4-inch trunks. Without lawn irrigation, give about 10 gallons per inch of trunk diameter each week in summer.
  2. Shrubs and perennials, which are slower and costlier to replace than lawns.
  3. Lawns, watered as allowed. Apply three-quarters to 1 inch on your watering days.

Ways to save water

  • Water between evening and mid-morning (CSU suggests 6 p.m. to 10 a.m.). Skip rain and windy days.
  • Check the soil first. If a 6-inch screwdriver slides in easily, you may not need to water.
  • Use cycle and soak on clay, slopes and compacted lawns.
  • Switch beds to drip or soaker hoses. CSU says drip plus organic mulch can cut water use by about half in beds and gardens.
  • Mulch. 3 to 4 inches around trees, 1 to 2 inches in flower beds, 3 inches or less in vegetable gardens.
  • Mow higher. Keep lawns at 2.5 to 3 inches and leave the clippings.
  • Adjust for shade. Shady areas may need up to half as much water as full sun.

How do I adjust irrigation after a rainstorm?

Turn the system off during rainy weather, then check the soil a few inches down before restarting. If it’s still moist, skip a watering or two. A rain shut-off sensor, which CSU says costs about $25, does this automatically. Soil-moisture sensors stop watering while the soil stays moist.

Common mistake

Watering on schedule even after rain. Always check the soil first.

Sources

Still have a question about your garden?

Ask Keith